#Fastcut review manuals

In fact, within a few months we had so much work for it that we have recovered the cost. We’re pleased to report our FastCut machine paid for itself much quicker than we expected. We did our research and concluded that the G7 Fabricator from FastCut offered the best value for our money.įor us it was a big investment. Our intention was to purchase a CNC machine to improve the quality of our products and speed up production.

We have a mid-size operation, supplying fabricated steel products for the resource extraction and mining industries. For some time we had been in the market for a CNC plasma cutter. We purchased a FastCut CNC plasma cutting system in the spring of 2013. 500 degree of square, easily achieved.įocusing on cut quality rather than inches per minute the cuts are better than lazer and waterjet that supplied our facility previously.

#Fastcut review manuals

Following the cutting parameters in the manuals initially, then tweaking the settings, the end result was impressive. Plasma cutting between ½ and 1 ¼ 44w plate was required immediately. Tech support by FastCut CNC and Victor was likely the best experience possible. Combining the training by FastCut CNC and onsite Victor install and training, the table was in operation quickly. Without any prior plasma cutting experience, the learning curve was steep.

Initial order until install and commission of Victor power source was as seamless as could be expected.Īs a manufacturer and supplier to the Western Canadian drilling industry, thicker plate (up to 2 inch oxy-air plasma and thicker section oxy-fuel ) are common. A local Canadian source as well as the FastCut CNC Team weighed positively in the decision process. FastCut CNC was chosen as a plasma table supplier after touring the manufacturing facility.